Double-wide, RV and carriage doors, heavy springs and tall-door openers handled right · (239) 342-5328

Finding the real fault

Garage Door Repair in Alva, Sized for Your Door

Repairs for doors that drag, lean, stick or stop halfway, whether the opening is a standard single or a wide, tall or wood door that has outgrown its hardware.

Ask about a repair — (239) 342-5328
Screwdriver, pliers and nails laid out on a white surface

A Big Door Hides Its Trouble Behind Its Size

On a large door, one worn part rarely fails quietly. A tired hinge or a weak spring makes everything around it carry extra, and the door's size spreads the strain across a wide, heavy panel. By the time it visibly sags, several parts may be affected.

We look at the entire door before picking up a wrench: the opener, the track, hinges, rollers, cables and springs. Then we fix what is actually at fault and tell you if anything nearby is close behind. Ordinary single doors get the same patient look, and the repair is sized to the problem.

Signs the Door Is Struggling

  • A leaning or sagging edge

    When one side rides lower or a wide door bows in the middle, hardware has loosened or a panel has lost its stiffness, and the door cannot close squarely.

  • Scraping and grinding

    Metal-on-metal sounds along the track often mean a worn roller, a bent track section or a hinge that has pulled loose from its panel.

  • Opener working too hard

    A motor that groans, slows or stops on the way up usually points to balance trouble, not a weak opener, and replacing the motor would not fix it.

How We Work Through a Repair

  1. 1

    Inspect the full system

    Every spring, cable, roller, hinge and track section is checked, and your account of the symptom tells us where to look first.

  2. 2

    Explain and agree

    You hear which part failed, what putting it right involves, and whether a sturdier part would suit a door this size better.

  3. 3

    Replace, align and test

    Failed parts come off, new ones go on square, and the door is run through full travel and balanced by hand before we finish.

Repair Questions

Should I keep using a door that is acting up?

Best to park it until someone has looked. A door that leans, jerks or grinds may be overloading a cable or spring, and when a heavy one gives way the damage is bigger. Tell us the symptoms and size and we will explain what is probably going on.

Will a repair work on a very large door?

Yes, as long as the replacement parts are rated for the opening. We measure width, height and weight first, then repair with hardware sized for the load rather than the lighter parts a standard door would take, which can mean a sturdier hinge, a heavier cable or an upgraded spring.

Do you repair ordinary doors too?

Absolutely. A standard single or double door gets the same inspection, the same careful repair and the same test at the end. Big doors are our particular strength, but they are not the only ones we handle.

Tell Us What the Door Is Doing

Share the size, the sounds and when the trouble began. A short phone conversation can often point to the likely cause before anyone arrives.

Describe the trouble at (239) 342-5328